Paper
15 May 1997 Printed circuit board visual inspection performance: a comparative analysis of mono- and stereovision macroscopic views
Steven F. Wiker, Ken Stewart, Tommey Meyers, Peregrin Spielholz
Author Affiliations +
Proceedings Volume 3012, Stereoscopic Displays and Virtual Reality Systems IV; (1997) https://doi.org/10.1117/12.274499
Event: Electronic Imaging '97, 1997, San Jose, CA, United States
Abstract
The objective of this study was to compare visual inspection performance of printed circuit boards (PCBs) and flexible circuit boards (flex) when using monovision and autostereovision modes of the Dimension Technologies' Virtual WindowTM. We measured completion times for visual inspections of PCBs and flex cards, and detection of manufacturing or post manufacturing defects in each of the products. In the case of printed circuit boards, the stereovision display mode produce faster inspection (approximately 17% improvement in inspection rate) when compared against the monovision mode. No change in inspection performance was observed with flex cards, or in the number of flaws detected, with the introduction of autostereovision. Recommendations are made for improving the effectiveness of the Virtual Window for visual inspection of printed circuit boards and like phenomena.
© (1997) COPYRIGHT Society of Photo-Optical Instrumentation Engineers (SPIE). Downloading of the abstract is permitted for personal use only.
Steven F. Wiker, Ken Stewart, Tommey Meyers, and Peregrin Spielholz "Printed circuit board visual inspection performance: a comparative analysis of mono- and stereovision macroscopic views", Proc. SPIE 3012, Stereoscopic Displays and Virtual Reality Systems IV, (15 May 1997); https://doi.org/10.1117/12.274499
Advertisement
Advertisement
RIGHTS & PERMISSIONS
Get copyright permission  Get copyright permission on Copyright Marketplace
KEYWORDS
Inspection

Optical inspection

Visualization

Microscopes

LCDs

Eye

Flexible circuits

RELATED CONTENT

Visual inspection as an organized procedure
Proceedings of SPIE (July 07 1995)
Automatic leather inspection of defective patterns
Proceedings of SPIE (February 21 1996)
Assessment Of Current Scratch Standards
Proceedings of SPIE (September 28 1987)

Back to Top