Paper
20 July 1998 CMOS chemical microsensors based on resonant cantilever beams
Dirk Lange, Andreas Koll, Oliver Brand, Henry Baltes
Author Affiliations +
Abstract
We present a chemical gas sensor based on a resonating cantilever beam in CMOS MEMS technology. The sensor is actuated employing electrothermal actuation. Thus, for a 300 micrometers long beam vibration amplitudes of 6.5 nm per mW heating power are achieved. The vibrations are detected with piezoresistors in a Wheatstone bridge scheme. Detection sensitivities above 200 (mu) V per mW heating power are measured with the bridge biased at 5 V. The beams have quality factors of up to 600. The static power dissipation that goes along with the electrothermal actuation scheme leads to a small temperature elevation of 0.3 K/mW of the sensitive area. The beams are coated with poly(etherurethane) as the sensitive layer. The layer thickness was determined by the change of the initial resonance frequency. Concentrations of octane, ethanol and toluene in synthetic air were measured. For toluene, concentrations as low as 250 ppm can be detected.
© (1998) COPYRIGHT Society of Photo-Optical Instrumentation Engineers (SPIE). Downloading of the abstract is permitted for personal use only.
Dirk Lange, Andreas Koll, Oliver Brand, and Henry Baltes "CMOS chemical microsensors based on resonant cantilever beams", Proc. SPIE 3328, Smart Structures and Materials 1998: Smart Electronics and MEMS, (20 July 1998); https://doi.org/10.1117/12.320174
Lens.org Logo
CITATIONS
Cited by 19 scholarly publications.
Advertisement
Advertisement
RIGHTS & PERMISSIONS
Get copyright permission  Get copyright permission on Copyright Marketplace
KEYWORDS
Sensors

Polymers

Wheatstone bridges

Silicon

Gas sensors

Bioalcohols

Microsensors

Back to Top