Paper
15 August 2000 Optimization of surface-micromachined patch antenna
S. M. Wong, Ban Leong Ooi, Pang Shyan Kooi, Tiong-Huat Ng, Ai Qun Liu
Author Affiliations +
Proceedings Volume 4176, Micromachined Devices and Components VI; (2000) https://doi.org/10.1117/12.395632
Event: Micromachining and Microfabrication, 2000, Santa Clara, CA, United States
Abstract
Although Microelectromechanical system (MEMS) technology has been used extensively in constructing microelectronic and micromechanical structures, there are very few reports on the research and development of MEMS antenna. This paper reports the investigation results of MEMS patch antennas in different shapes and structures. Like conventional patch antenna, MEMS patch antenna has narrow bandwidth, however, it is found among three basic shapes: circular, square and triangular.Square patch antenna has the best overall performance. Two simple methods to improve the performances of MEMS patch antenna are also proposed. When the feed inset position in polysilicon layer of a MEMS microstrip patch antenna is optimized, the impedance bandwidth of the antenna can be enhanced without deteriorating the radiation pattern of the antenna. Also, the resonance frequency of MEMS patch antenna is reduced by etching holes on the radiating patch.
© (2000) COPYRIGHT Society of Photo-Optical Instrumentation Engineers (SPIE). Downloading of the abstract is permitted for personal use only.
S. M. Wong, Ban Leong Ooi, Pang Shyan Kooi, Tiong-Huat Ng, and Ai Qun Liu "Optimization of surface-micromachined patch antenna", Proc. SPIE 4176, Micromachined Devices and Components VI, (15 August 2000); https://doi.org/10.1117/12.395632
Advertisement
Advertisement
RIGHTS & PERMISSIONS
Get copyright permission  Get copyright permission on Copyright Marketplace
KEYWORDS
Antennas

Microelectromechanical systems

Gold

Polarization

Silicon

Etching

Fabrication

RELATED CONTENT


Back to Top