Paper
27 December 2002 Cr photomask etch performance and its modeling
Author Affiliations +
Abstract
Mathematical prediction of dry etch results have been difficult, if not impossible, over the years due to the complexity inherent in plasma processing. With device requirements tightening combined with the high cost of running test masks, it becomes even more important for process engineers to have some means by which to model accurately this increasingly complex activity. In this paper, a correlation between a novel, plasma chrome etch model and empirical data will be presented. Practical effects of chrome loading are also discussed. From the empirical data side, studies on the photomask chrome etch process using e-beam resists were carried out following strict design of experiments (DOE) format. Photomask chrome etch processes with different resists (ZEP and positive CAR) were investigated using a Unaxis VLR 770 ICP etcher and an AMAT Tetra etcher. A Toshiba EBM-3500B (50KeV) was used for the pattern writing on positive CAR resist. A KLA-Tencor P12-EX profiler, Leica LWM 250 UV CD optical measurement system, and a KLA-Tencor 8250XP-R CD SEM were used for metrology and product characterization. Significant etch performance differences were shown on these etchers irrespective of the resist type used. A special measurable number was defined and found to have a linear relationship with etch movement on both AMAT and VLR etchers.
© (2002) COPYRIGHT Society of Photo-Optical Instrumentation Engineers (SPIE). Downloading of the abstract is permitted for personal use only.
Banqiu Wu and David Y. Chan "Cr photomask etch performance and its modeling", Proc. SPIE 4889, 22nd Annual BACUS Symposium on Photomask Technology, (27 December 2002); https://doi.org/10.1117/12.467581
Lens.org Logo
CITATIONS
Cited by 9 scholarly publications.
Advertisement
Advertisement
RIGHTS & PERMISSIONS
Get copyright permission  Get copyright permission on Copyright Marketplace
KEYWORDS
Etching

Chromium

Photomasks

Plasma etching

Plasma

Cadmium

Photoresist processing

RELATED CONTENT

Multi layer resist system for 45 nm node and beyond...
Proceedings of SPIE (October 20 2006)
Photomask dry-etching techniques for hard mask
Proceedings of SPIE (May 20 2006)
Improvement of mask CD uniformity for below 45 nm node...
Proceedings of SPIE (October 30 2007)
Investigation of Cr etch kinetics
Proceedings of SPIE (December 17 2003)
Cr and MoSi photomask plasma etching
Proceedings of SPIE (June 02 2003)

Back to Top