Paper
29 September 2004 Design of reflection-retarders using non-negative film-substrate systems
Author Affiliations +
Abstract
A reflection-type film-substrate retarder is an optical device that changes the relative phase but not the relative amplitude of light upon reflection from a film-substrate system. While there are several such device designs based on the common negative film-substrate system, very little has been done with the other two categories of systems; zero and positive. The system category is determined by the relationship between the refractive indices of the ambient (N0), film (N1), and substrate (N2). If N1<√N0N2, the system is negative; if N1=√N0N2, the system is zero; and if N1>√N0N2, the system is positive . This paper discusses the design procedure and characteristics of zero-system reflection-retarders. The polarization and ellipsometric properties of the positive system preclude the existence of a reflection-retarder. First, a brief characterization of the zero and positive systems using constant-angle-of-incidence contours (CAICs) and Constant-thickness contours (CTCs) of the ellipsometric function is presented and discussed. Then, an algorithm outlining the design procedures is presented, and the characteristics of the obtained designs are optimized, analyzed and discussed.
© (2004) COPYRIGHT Society of Photo-Optical Instrumentation Engineers (SPIE). Downloading of the abstract is permitted for personal use only.
A. R. M. Zaghloul and Jamie Scott Mason "Design of reflection-retarders using non-negative film-substrate systems", Proc. SPIE 5527, Advances in Thin Film Coatings for Optical Applications, (29 September 2004); https://doi.org/10.1117/12.562952
Advertisement
Advertisement
RIGHTS & PERMISSIONS
Get copyright permission  Get copyright permission on Copyright Marketplace
KEYWORDS
Wave plates

Reflection

Scanning probe microscopy

Reflectivity

Refractive index

Polarization

Grazing incidence

Back to Top