Paper
5 May 2010 Dielectric charging control for electrostatic MEMS switches
Manuel Domínguez, David López, David Molinero, Joan Pons-Nin
Author Affiliations +
Abstract
This work introduces a new control method to dynamically mitigate the effects of the parasitic charge injected in dielectric layers of electrostatic MEMS switches. This method can be used to increase lifetime and reliability of electrostatically actuated MEMS devices. The method is based on the opposite behaviors exhibited by the dielectric charging phenomena when voltage stresses of different polarity are applied to a given device. To this effect, a sigmadelta sensing and actuation scheme has been implemented: device capacitance is periodically sampled and, according to the value obtained, positive or negative actuation voltages are applied. Preliminary experimental results with two different MEMS devices that demonstrate the feasibility of this method are introduced and discussed.
© (2010) COPYRIGHT Society of Photo-Optical Instrumentation Engineers (SPIE). Downloading of the abstract is permitted for personal use only.
Manuel Domínguez, David López, David Molinero, and Joan Pons-Nin "Dielectric charging control for electrostatic MEMS switches", Proc. SPIE 7679, Micro- and Nanotechnology Sensors, Systems, and Applications II, 76792J (5 May 2010); https://doi.org/10.1117/12.853177
Lens.org Logo
CITATIONS
Cited by 12 scholarly publications.
Advertisement
Advertisement
RIGHTS & PERMISSIONS
Get copyright permission  Get copyright permission on Copyright Marketplace
KEYWORDS
Microelectromechanical systems

Capacitance

Dielectrics

Switches

Control systems

Silicon

Reliability

RELATED CONTENT

Electrostatically deformable microfrequency selective surface
Proceedings of SPIE (November 04 2002)
A novel multi-actuation CMOS RF MEMS switch
Proceedings of SPIE (December 30 2008)
A study on high isolation RF MEMS switch
Proceedings of SPIE (February 07 2006)
The reliability of RF MEMS failure modes, test procedures,...
Proceedings of SPIE (December 23 2003)

Back to Top