Fast and low noise optical receiver using Si APD for cloud-aerosol LIDAR

Khaled Gasmi

doi:10.1117/12.2227581

29 April 2016 Fast and low noise optical receiver using Si APD for cloud-aerosol LIDAR

Khaled Gasmi

Proceedings Volume 9899, Optical Sensing and Detection IV; 98990I (2016) https://doi.org/10.1117/12.2227581
Event: SPIE Photonics Europe, 2016, Brussels, Belgium

Abstract

A Fast and Low-noise Optical Receiver using a Silicon Avalanche Photodiode with an internal gain of 100 connected to a Broadband Preamplifier Circuit was developed. The optical receiver and the receiving optics form the detection channel of a Cloud-Aerosol Lidar Remote Sensing System used to measure profiles of aerosol and cloud backscatter at the near-infrared wavelength of 1064 nm. While a 10 Hz repetition rate solid state pulsed Nd:YAG laser emitting at 1.06 μm and the emission optics form the transmission channel. The preamplifier circuit with a 300 MHz bandwidth and a gain of 10 is capable of accommodating laser pulses of 10 ns full width at half maximum. The preamplifier matches 50 Ω impedances at the input and the output sides. The input matching is used to reduce the Johnson noise and hence a much better sensitivity was achieved. The output matching was useful when this preamplifier is to be connected to other instrumentation requiring 50 Ω impedance matching or to be interfaced in cascade to increase the overall gain of the detection chain. These 50 Ω impedances at the input and output sides, also allows using the preamplifier coupled with a photodiode at the input in the detection of fast signals without distortion or integration. A low noise level at the preamplifier circuit input of only 1.6 nV/Hz^1/2 and a very good linearity from 1 KHz to 280 MHz were achieved, allowing the transmission of the backscattered signal to the acquisition system without distortion. In addition, the experimental characterization of the optical receiver coupled with the receiving optics showed good detection performance of the lidar detection channel: A low Noise Equivalent Power of 50 pW/Hz^1/2 and a high Signal-to- Noise Ratio of 2 were achieved. Furthermore, the maximal range of the lidar remote sensing system was estimated.

Citation Download Citation

Khaled Gasmi "Fast and low noise optical receiver using Si APD for cloud-aerosol LIDAR", Proc. SPIE 9899, Optical Sensing and Detection IV, 98990I (29 April 2016); https://doi.org/10.1117/12.2227581

ACCESS THE FULL ARTICLE

INSTITUTIONAL
Select your institution to access the SPIE Digital Library.

SELECT YOUR INSTITUTION

PERSONAL
Sign in with your SPIE account to access your personal subscriptions or to use specific features such as save to my library, sign up for alerts, save searches, etc.

PERSONAL SIGN IN

No SPIE Account? Create one

PURCHASE THIS CONTENT

SUBSCRIBE TO DIGITAL LIBRARY

50 downloads per 1-year subscription

Members: $195

Non-members: $335 ADD TO CART

25 downloads per 1 - year subscription

Members: $145

Non-members: $250 ADD TO CART

PURCHASE SINGLE ARTICLE

Includes PDF, HTML & Video, when available

Members: $17.00

Non-members: $21.00 ADD TO CART

PROCEEDINGS
14 PAGES

DOWNLOAD PAPER SAVE TO MY LIBRARY

GET CITATION

RIGHTS & PERMISSIONS

Get copyright permission Get copyright permission on Copyright Marketplace

KEYWORDS

LIDAR

Signal detection

Signal to noise ratio

Interference (communication)

Receivers

Silicon

Clouds

Show All Keywords

Keywords/Phrases

Search In:

Publication Years