1 April 1976 Generating an Error Analysis for an Airborne Radiometric System
A. J. Verderese
Author Affiliations +
Abstract
This paper presents an error analysis for an airborne radiometric system. The system under scrutiny is a scanning radiometer operating at two wavelengths in either a warm or cold mode. Each wavelength channel consists of an array of N detectors. The long wavelength channel is used for display purposes (acquisition, tracking), whereas both channels are used for data reduction purposes. The data are recorded on analog and digital tapes (both sensor as well as general housekeeping data), reformatted and made ready to undergo stan-dard Fortran type operations. The sensor data consist primarily of target voltage waveforms interspersed among erroneous voltage pulses and white noise. It is desired to ascertain the peak values of the target voltage pulses and relate these peak values to target irradiances via the a priori laboratory calibration. Hence, it is observed that the errors can be classified as belonging to one of the following subsystems: 1) Calibration 2)The sensor itself 3) Data processing and reduction
A. J. Verderese "Generating an Error Analysis for an Airborne Radiometric System," Optical Engineering 15(2), 152166 (1 April 1976). https://doi.org/10.1117/12.7971940
Published: 1 April 1976
Advertisement
Advertisement
RIGHTS & PERMISSIONS
Get copyright permission  Get copyright permission on Copyright Marketplace
KEYWORDS
Error analysis

Sensors

Calibration

Analog electronics

Data acquisition

Data processing

Digital recording

RELATED CONTENT

Oil-film dynamic coefficient testing system
Proceedings of SPIE (September 02 2003)
Laboratory Calibration Of Field Reflectance Panels
Proceedings of SPIE (October 12 1988)
Computerized Rapid-Scan Spectroscopy At Navwpnsuppcen, Crane
Proceedings of SPIE (September 14 1977)
A Novel Timing Recovery for Read Channel Systems using a...
Proceedings of SPIE (September 09 2004)

Back to Top