We report the effect of electric field and of thin encapsulation layers on the lifetime of silicone-based dielectric elastomer actuators (DEAs), for different environmental conditions under DC actuation. The dielectric is Elastosil 2030/20, and the encapsulation layer is a soft silicone elastomer. We conduct our tests from 20°C to 85°C, and from 20% RH to 90% RH. increasing the electric field from 90 V/μm (3.5% actuation strain) to 110 V/μm (7% actuation strain) yields 140x lower lifetimes at 85°C – 85% RH. Encapsulating the DEAs increases DC lifetime of factors up to 30x, with negligible reduction in actuation strain.
We report an experimental investigation of the lifetime of dielectric elastomer actuators (DEAs) under constant DC actuation, with a characterization setup which allows the monitoring of strain and resistance over time for 6 DEAs in parallel. We show how the choice of the electrode influences the lifetime of silicone-based DEAs under constant DC actuation and under different environmental conditions. The DEAs consist of a 12 μm thick prestretched Elastosil 2030 silicone membrane sandwiched between 1 - 4 μm thick and 5 mm diameter circular electrodes. Three types of electrodes are used: 1) pad-printed carbon powder - PDMS composite, 2) inkjet-printed carbon black suspension, and 3) carbon black powder. The DEAs are operated under a constant DC electric field in controlled temperature and humidity, ranging from 30% RH at 20°C to 85% RH at 85°C. 6 DEAs were tested simultaneously for each experimental condition (electrode type, % RH, T). Operated at an electric field of 90 V/μm, at 85°C and at 85% RH, DEAs with pad-printed electrodes show more than 10x higher lifetimes than DEAs with inkjet-printed electrodes. However, no significant difference in lifetime is seen at dry conditions. When operating at electric fields chosen to have the same actuation strain for the different DEAs, those with dry carbon black electrodes show over 5x higher lifetimes compared to DEAs with pad-printed or inkjet-printed DEAs, owing to the lower operational electric field required (50 V/μm vs. 90 V/μm) to reach a given strain. At 85°C, increasing the humidity from 20% RH to 85% RH leads to a 40x to 400x decrease in lifetime for DEAs with pad-printed and with inkjet-printed DEAs.
This work presents how the lifetime of silicone-based dielectric elastomer actuators (DEAs) is affected by the choice of silicone elastomer material, humidity and temperature at constant DC electric fields and membrane prestretch. High (>50%RH) humidity levels are found to significantly decrease the lifetime of silicone-based DEAs under DC actuation, whereas temperature and the type of silicone elastomer have a more limited impact. Under a constant DC electric field of 83V/μm and a membrane prestretch of 1.3, all DEAs operating at 80°C – 90%RH fail within 24 hours whereas DEAs actuated at 20°C – 10%RH all survive over 14 days without any failure.
Access to the requested content is limited to institutions that have purchased or subscribe to SPIE eBooks.
You are receiving this notice because your organization may not have SPIE eBooks access.*
*Shibboleth/Open Athens users─please
sign in
to access your institution's subscriptions.
To obtain this item, you may purchase the complete book in print or electronic format on
SPIE.org.
INSTITUTIONAL Select your institution to access the SPIE Digital Library.
PERSONAL Sign in with your SPIE account to access your personal subscriptions or to use specific features such as save to my library, sign up for alerts, save searches, etc.