As a platform for high resolution bioimaging, biochips with a refractive index very close to that of a culture medium (water) are highly demanded. CYTOP (AGC Corporation) is a promising material, since its refractive index (1.34) is almost similar to that of water (1.33). However, high transparency in also the ultraviolet region and high chemical resistance of CYTOP make it difficult to fabricate 3D microstructures for biochips. In this study we present fabrication method of 3D biochips based on CYTOP for cell observation by the molding process using 3D micro/nanostructures fabricated by two-photon polymerization with femtosecond laser.
The GHz burst mode femtosecond (fs) laser pulses have attracted considerable attention because they can perform better quality and higher efficiency ablation compared to the conventional irradiation scheme of fs pulses (single-pulse mode). Recently, we have demonstrated that the GHz burst mode fs laser pulses can create two-dimensional (2D) periodic surface structures (LIPSS) on Si surfaces. In this paper, we extend the GHz burst mode fs laser processing to form LIPSS on Ti plates. Our aim was to further investigate the more detailed mechanism and explore practical applications. Although the material characteristics of Ti are significantly different from Si, the GHz burst mode fs laser pulses can also create 2D-LIPSS. Then, mesenchymal stem cells cultured on the formed 2D-LIPSS were found to exhibit different behavior on 1D-LIPSS as compared with bare Ti surfaces.
A method is demonstrated for large-scale micro-through-hole (MTH) array fabrication in glass substrates for an advanced digital nucleic acid amplification technique (NAAT). The fabricated chip is advantageous to current partitioning devices in terms of speed, cost, and simplicity. To satisfy the requirement of MTH quantities for valid nucleic acid statistics, we improve the laser processing speed by focusing ultrafast Bessel pulses into a glass substrate under continuous translation. A single Bessel pulse can result a single MTH, and hundreds to thousands of MTHs can be produced per second. Preliminary digital NAAT experiment shows promising results of reagent partitioning of the fabricated chip. This work offers a highly efficient and low-cost scheme for glass-based reagent partitioning that will contribute to the wide accessibility of advanced digital NAATs.
KEYWORDS: Super resolution, Polymers, Microfluidics, 3D microstructuring, Two photon polymerization, Fabrication, Water, Femtosecond phenomena, Transparency, Refractive index
Development of biochips enabling distortion-free imaging in the microchannel filled with a culture medium (water) is required to investigate behavior of living cells in micro and nano environments. Fluoropolymer CYTOP is a promising material as a platform of biochips for the distortion-free imaging, because the refractive index of CYTOP (1.34) is almost same as 1.33 of water. In this study, we have developed a new 3D fabrication method for CYTOP by two-photon polymerized structures using a femtosecond laser as molds, which will be used for fabrication of micro and nano environment platforms for super-resolution bioimaging.
Access to the requested content is limited to institutions that have purchased or subscribe to SPIE eBooks.
You are receiving this notice because your organization may not have SPIE eBooks access.*
*Shibboleth/Open Athens users─please
sign in
to access your institution's subscriptions.
To obtain this item, you may purchase the complete book in print or electronic format on
SPIE.org.
INSTITUTIONAL Select your institution to access the SPIE Digital Library.
PERSONAL Sign in with your SPIE account to access your personal subscriptions or to use specific features such as save to my library, sign up for alerts, save searches, etc.