We recently developed a holmium-doped triple-clad fiber (Ho-3CF) for laser emission beyond 2.1 μm. In a clad-pumped fiber laser oscillator emitting at 2.12 μm, we obtained an optical efficiency of 73% with respect to the absorbed pump power at 1.94 μm, and a maximum signal power of 62 W. We present here the comparison between the laser measurements and a numerical simulation, together with the measurements of the required physical parameters (crosssections, attenuations…). The alumino-silicate core composition of our initial Ho-3CF samples required the introduction of a pedestal to preserve the single spatial-mode guiding. We also present our preliminary results on a new aluminophospho-silicate core composition, in order to suppress the initial pedestal and simplify the fabrication process. Both samples were also analyzed in core-pumped laser configuration.
We present here the development of ultra-low NA large mode area neodymium doped alumino-phospho-silica fibers with different clad-to-core ratios for high power laser emission around 910nm. This ratio is determinant in the competition between the 3-level transition at 910nm and 4-level transition of neodymium at 1060nm. The study shows that the 30/130µm (core/cladding) fiber was the most efficient, with a record output power of 83W at 910nm, yielding a 47% slope efficiency and a good beam quality (M²~1.5). Parasitic power at 1060nm was kept lower than 1W and no sign of roll-off was observed at maximum pump power.
We present in this work, the development of a nanosecond pulsed Master-Oscillator Power-Amplifier (MOPA) laser system near 905 nm based on the 3-level transition of Neodymium using a novel low NA polarization-maintaining Nd-doped silica fiber with a 30µm core and 130µm cladding. The MOPA delivered up to 24 W of average power (0.6 mJ energy per pulse) with good beam quality (M²~1.4). Cascaded LBO and BBO crystals are used respectively for second-harmonic generation and fourth-harmonic generation, giving respectively average output powers of 4.9W at 452nm (conversion efficiency of 20%) and 550mW at 226nm (conversion efficiency of 10%).
We present the fabrication by Surface Plasma Chemical Vapor Deposition (SPCVD) and All Solution Doping (ASD) of step-index Nd-doped fibers with a 30/125μm (core/cladding diameters) geometry and a low numerical aperture (NA) near 0.05. A phospho-alumino-silicate (SiO2-Al2O3-P2O5-Nd2O3) core composition was used to reduce the formation of Nd3+ ions clusters while keeping a low refractive index through the peculiar AlPO4 chemical complex. Operated in CW laser regime, a 0.053 NA fiber generated up to 17W of output power at 921nm, limited by the available pump power at 808nm (51W), yielding a 37% power conversion efficiency. The profile of the output beam for a bend diameter of ~12cm is gaussian and nearly diffraction limited (M2 ~1.1). This is in good agreement with the large discrepancy, in terms of calculated bending losses, between the fundamental LP01 and the higher order modes.
Access to the requested content is limited to institutions that have purchased or subscribe to SPIE eBooks.
You are receiving this notice because your organization may not have SPIE eBooks access.*
*Shibboleth/Open Athens users─please
sign in
to access your institution's subscriptions.
To obtain this item, you may purchase the complete book in print or electronic format on
SPIE.org.
INSTITUTIONAL Select your institution to access the SPIE Digital Library.
PERSONAL Sign in with your SPIE account to access your personal subscriptions or to use specific features such as save to my library, sign up for alerts, save searches, etc.