Paper
17 May 1994 Overcoming global topography and improving lithographic performance using a transmittance controlled mask
Woo-Sung Han, Chang-Jin Sohn, Hoyoung Kang, Young-Bum Koh, Moon-Yong Lee
Author Affiliations +
Abstract
As device density increases, topography gets more severe and optical proximity effect becomes worse. If light intensity can be controlled for individual patterns, linewidth variation over topography and optical proximity effect can also be minimized. A new method to solve these problems named transmittance controlled mask (TCM) is proposed. TCM is such a mask that thin absorptive films remain on the areas where light attenuation is necessary. In this paper, TCM is prepared and evaluated in view of topography and optical proximity effect improvement as well as process latitude improvement. Greatly improved process latitude was observed over 1.5 micrometers aluminum topography with TCM, while no process latitude was obtained with conventional masks even over 0.9 micrometers topography. Good optical proximity control is also possible with TCM.
© (1994) COPYRIGHT Society of Photo-Optical Instrumentation Engineers (SPIE). Downloading of the abstract is permitted for personal use only.
Woo-Sung Han, Chang-Jin Sohn, Hoyoung Kang, Young-Bum Koh, and Moon-Yong Lee "Overcoming global topography and improving lithographic performance using a transmittance controlled mask", Proc. SPIE 2197, Optical/Laser Microlithography VII, (17 May 1994); https://doi.org/10.1117/12.175408
Lens.org Logo
CITATIONS
Cited by 1 scholarly publication.
Advertisement
Advertisement
RIGHTS & PERMISSIONS
Get copyright permission  Get copyright permission on Copyright Marketplace
KEYWORDS
Photomasks

Transmittance

Chromium

Aluminum

Lithography

Semiconducting wafers

Absorption

RELATED CONTENT

Lithographic performance of a new “low-k” mask
Proceedings of SPIE (May 10 2016)
A lift off of pattern structures on the heat mode...
Proceedings of SPIE (July 08 2019)
Application of dry etching to 1-Gb DRAM mask fabrication
Proceedings of SPIE (September 01 1998)
Hot electron emission lithography
Proceedings of SPIE (June 25 1999)

Back to Top