Paper
15 March 2006 Mitigation of acoustic resonance using electrically shunted loudspeakers
Andrew J. Fleming, Dominik Niederberger, S. O. Reza Moheimani, Manfred Morari
Author Affiliations +
Abstract
Low-frequency reverberant sound fields are usually suppressed by means of either adaptive feedforward control or Helmholtz resonator. In this paper, an electrical impedance is connected to the terminals of an acoustic loudspeaker, the mechanical dynamics, and hence acoustic response can be made to emulate a sealed acoustic resonator. No microphone or velocity measurement is required. In some cases, the required electrical circuit is simply the parallel connection of a capacitor and resistor. Experimental application to a closed acoustic duct results in 14 dB pressure attenuation of a single acoustic mode.
© (2006) COPYRIGHT Society of Photo-Optical Instrumentation Engineers (SPIE). Downloading of the abstract is permitted for personal use only.
Andrew J. Fleming, Dominik Niederberger, S. O. Reza Moheimani, and Manfred Morari "Mitigation of acoustic resonance using electrically shunted loudspeakers", Proc. SPIE 6169, Smart Structures and Materials 2006: Damping and Isolation, 616918 (15 March 2006); https://doi.org/10.1117/12.659022
Advertisement
Advertisement
RIGHTS & PERMISSIONS
Get copyright permission  Get copyright permission on Copyright Marketplace
KEYWORDS
Acoustics

Resonators

Resistors

Electroluminescence

Velocity measurements

Signal attenuation

Capacitors

Back to Top