Paper
10 July 2008 Replacement of the Green Bank Telescope azimuth track
Author Affiliations +
Abstract
The azimuth track of the Green Bank Telescope did not perform as designed. Relative movement of components was noted during construction; in addition, fretting of the base plate and wear plate faying surfaces, fatigue cracking of the wear plates, fatigue failure of wear plate fasteners, and deterioration of the cementitous grout layer occurred at a rapid pace during the first few years of operation. After extensive failure analysis, a new system of components was designed and fabricated, and installation of the components was performed during 2007 (Symmes, Anderson, and Egan, "Improving the service life of the 100m Green Bank Telescope azimuth track", SPIE 7012-121). The highlights and lessons learned during the fabrication and installation phases are described herein. This information will benefit any organization performing a similar replacement, and may be helpful in new installations as well.
© (2008) COPYRIGHT Society of Photo-Optical Instrumentation Engineers (SPIE). Downloading of the abstract is permitted for personal use only.
Robert Anderson, Arthur Symmes, and Dennis Egan "Replacement of the Green Bank Telescope azimuth track", Proc. SPIE 7012, Ground-based and Airborne Telescopes II, 701237 (10 July 2008); https://doi.org/10.1117/12.784807
Lens.org Logo
CITATIONS
Cited by 4 scholarly publications.
Advertisement
Advertisement
RIGHTS & PERMISSIONS
Get copyright permission  Get copyright permission on Copyright Marketplace
KEYWORDS
Telescopes

Distortion

Connectors

Epoxies

Inspection

Manufacturing

Californium

RELATED CONTENT


Back to Top