Measuring concentricity and coaxial tolerance of nozzle and cavity with tool microscope

Xizhao Lu; Feng Jiang; Ruifang Ye; Tingping Lei

doi:10.1117/12.2214472

26 January 2016 Measuring concentricity and coaxial tolerance of nozzle and cavity with tool microscope

Xizhao Lu, Feng Jiang, Ruifang Ye, Tingping Lei

Proceedings Volume 9903, Seventh International Symposium on Precision Mechanical Measurements; 990328 (2016) https://doi.org/10.1117/12.2214472
Event: Seventh International Symposium on Precision Mechanical Measurements, 2015, Xia'men, China

Abstract

While the equipment of Micro-jet wave-guided laser was assembled, high-precision of concentricity and coaxiality between nozzle and cavity are required, which directly or indirectly influent the laser coupling precision of nozzle, the micro-jet stability and the steady length of micro-jet as well. As a result, the measurement of concentricity and coaxiality is important to improve the processing quality of Micro-jet wave-guided laser Through the new digital universal tool microscope measuring both ends of micro nozzle and diameter of nozzle, more resolution the other hand, the backlight detection the edge of nozzle is utilized. When the position of the center of a circle is indirect measured and then find out the concentricity through the uncertainty of the measurement and calculation method. V shaped groove is utilized to make certain its position. Otherwise, digital imaging through setting fixture and the use of new digital universal tool microscope and processed by software, which will cause to reduce measurement human error in tradition, after that, error theory analysis will be carried out, uncertainty theory will be utilized to make the experiment more sure at the same time. Above all, the reliability of data is obtained, compared with the traditional measurement methods are more accurate. Therefore, the processing quality of laser drilling will be enhanced significantly.

Citation Download Citation

Xizhao Lu, Feng Jiang, Ruifang Ye, and Tingping Lei "Measuring concentricity and coaxial tolerance of nozzle and cavity with tool microscope", Proc. SPIE 9903, Seventh International Symposium on Precision Mechanical Measurements, 990328 (26 January 2016); https://doi.org/10.1117/12.2214472

ACCESS THE FULL ARTICLE

INSTITUTIONAL
Select your institution to access the SPIE Digital Library.

SELECT YOUR INSTITUTION

PERSONAL
Sign in with your SPIE account to access your personal subscriptions or to use specific features such as save to my library, sign up for alerts, save searches, etc.

PERSONAL SIGN IN

No SPIE Account? Create one

PURCHASE THIS CONTENT

SUBSCRIBE TO DIGITAL LIBRARY

50 downloads per 1-year subscription

Members: $195

Non-members: $335 ADD TO CART

25 downloads per 1 - year subscription

Members: $145

Non-members: $250 ADD TO CART

PURCHASE SINGLE ARTICLE

Includes PDF, HTML & Video, when available