Paper
20 September 2002 Two-dimensional birefringence measurement using liquid crystal retarder for plastic disk inspection
Author Affiliations +
Abstract
A plastic disk for the next generation of an optical disk and/or a hard disk requires high quality surface. Especially its flatness is very important. Moreover surface conditions of disks are very important for covered thin film. A plastic disk inspection system is proposed by using a two-dimensional birefringence distribution using liquid crystal rederders. If there is an internal strain or a residual stress in disk, small birefringence can be observed. It is necessary for the birefringence measurement to determine the relative retardation and the azimuthal angle of the fast axis in plastic disks. In this paper, a measurement system of two-dimensional birefringence distribution is proposed. Several images captured by a CCD camera are sufficient for one birefringence distribution analysis. These experimental procedures and the results of plastic disks are discussed.
© (2002) COPYRIGHT Society of Photo-Optical Instrumentation Engineers (SPIE). Downloading of the abstract is permitted for personal use only.
Yukitoshi Otani, Lianhua Jin, and Yuki Sakaino "Two-dimensional birefringence measurement using liquid crystal retarder for plastic disk inspection", Proc. SPIE 4919, Advanced Materials and Devices for Sensing and Imaging, (20 September 2002); https://doi.org/10.1117/12.465750
Advertisement
Advertisement
RIGHTS & PERMISSIONS
Get copyright permission  Get copyright permission on Copyright Marketplace
KEYWORDS
Birefringence

Liquid crystals

Wave plates

Inspection

Optical discs

Phase shifting

CCD cameras

Back to Top