Paper
14 February 2012 Sub-80-fs timing jitter of a stabilized SESAM modelocked VECSEL
V. J. Wittwer, R. van der Linden, B. Resan, K. J. Weingarten, T. Südmeyer, U. Keller
Author Affiliations +
Abstract
We present timing jitter measurements of an actively stabilized SESAM modelocked VECSEL generating 4-ps pulses with 2-GHz repetition rate and 20-mW average output power. The repetition rate was phase-locked to a reference source using a piezo actuator. The timing phase noise power spectral density of the laser output was measured with an Agilent E5052B Signal Source Analyzer. The resulting rms timing jitter integrated over an offset frequency range from 1 Hz to 1 MHz gives a timing jitter of below 80 fs, several times lower than previous modelocked VECSELs and comparable to the noise performance of ion-doped solid-state-lasers.
© (2012) COPYRIGHT Society of Photo-Optical Instrumentation Engineers (SPIE). Downloading of the abstract is permitted for personal use only.
V. J. Wittwer, R. van der Linden, B. Resan, K. J. Weingarten, T. Südmeyer, and U. Keller "Sub-80-fs timing jitter of a stabilized SESAM modelocked VECSEL", Proc. SPIE 8242, Vertical External Cavity Surface Emitting Lasers (VECSELs) II, 82420Z (14 February 2012); https://doi.org/10.1117/12.906356
Advertisement
Advertisement
RIGHTS & PERMISSIONS
Get copyright permission  Get copyright permission on Copyright Marketplace
KEYWORDS
Semiconductor lasers

Laser stabilization

Actuators

Oscillators

Diodes

Interference (communication)

Semiconductors

Back to Top