The excimer laser, with advantages of short wavelength, high energy, and tunable repetition rate, serves as an alternative device for inertial confinement fusion (ICF). However, the current bulky size of excimer lasers presents challenges for engineering implementation, leading to significant engineering difficulties. Modularization of diodes proves to be an effective approach for reducing device volume and engineering complexity. The goal of modularization is to achieve higher efficiency and reliability within a smaller footprint, where numerical calculations of electrostatic fields play a crucial role in realizing these objectives. This paper introduces the applications of electrostatic field numerical calculations in diode insulation structure design, suppression of cathode edge emission effects, and mitigation of electron beam scrapping effects, underscoring the scenarios where excimer laser diodes necessitate the utilization of electrostatic field calculations in their design. The research presented herein can serve as a reference for enhancing the efficiency and reliability of electron-beam-pumped excimer laser diodes.
Excimer lasers driven by linear transform driver (LTD) are expected to be used in inertial confinement fusion (ICF). The main problem of LTD in excimer lasers is synchronous triggering on multiple circuits, gas spark switches are important for synchronous triggering, which are required to be fired with low prefire probability and jitter. Multi-gap switch, as a kind of the gas spark switches, is always used in LTD. In this paper, a comparison study of corona discharge current of a multi-gap switch for LTD from the aspects of self-breakdown voltage and jitter is presented. The length of equalizing voltage needle was optimized by the electrical strength simulation. Using the optimized needle, the corona currents of the two gaps were measured, then it was found that the corona currents differ when the lengths of the corona needles were equal. To study if the difference of current in each gap affects the breakdown voltage and jitter of the switch, the length of the needle was adjusted to make the corona current the same. Then the breakdown voltage and jitter were measured under the two conditions of equal and unequal corona currents. It can be found that smaller the difference of current in each gap, higher the breakdown voltage and lower the jitter of the switch. It can be concluded that the corona needle can be adjusted to make corona current of each gap equal, which can be beneficial to increase the breakdown voltage and lower the jitter of the switch.
The square pulse output of Linear transformer driver (LTD) is of great interest for excimer lasers, where the efficiency can be greatly improved in this way. The design of square pulse output LTD within the single cavity was presented, then the influence of jitter and loop inductance on square pulse output was studied, it can be found that the higher the value of the jitter and loop inductance, the more the risetime of the voltage pulse, which hinders the shaping of the square pulse output. Then the method to change the square pulse width by varying the triggering times was presented, through the simulation, it is found that when the triggering interval is set to 15s, the square pulse characteristics of the voltage output are more obvious, the flat top is flat, and the pulse width is wider. The bricks within the single cavity can be designed by two methods, where the one is using the same sized capacitors, the other is using the different sized capacitors to synthesize a flat voltage pulse, the choice of the two methods should be based on the cost and requirements of the excimer laser, including the amplitude of the output voltage, the pulse width and the laser beam quality. The reference of designing the square pulse LTD can be provided by this paper
Access to the requested content is limited to institutions that have purchased or subscribe to SPIE eBooks.
You are receiving this notice because your organization may not have SPIE eBooks access.*
*Shibboleth/Open Athens users─please
sign in
to access your institution's subscriptions.
To obtain this item, you may purchase the complete book in print or electronic format on
SPIE.org.
INSTITUTIONAL Select your institution to access the SPIE Digital Library.
PERSONAL Sign in with your SPIE account to access your personal subscriptions or to use specific features such as save to my library, sign up for alerts, save searches, etc.