This will count as one of your downloads.
You will have access to both the presentation and article (if available).
In this work we explore the different multipatterning options for lines and blocks at pitches below 20 nm. As such, we will demonstrate and compare three different patterning options to enable 16 nm pitch gratings: 193i-based SAOP, EUV-based SADP and EUV-based SAQP. Finally, we will also elaborate on a self-aligned patterning scheme which does not define lines and blocks sequentially anymore but integrates them in a mixed mode. This patterning approach (SALELE) makes use of two LE masks and two self-aligned block masks. We will present its development status at relaxed pitch (28 nm) and discuss its advantages for future technology nodes.
As plasma etching is known to reduce line edge roughness on 193nm lithography printed features [2], we investigate in this paper the level of roughness that can be achieved on EUV photoresist exposed at a lower dose through etch process optimization into a typical back end of line film stack. We will study 16nm lines printed at 32 and 34nm pitch. MOX and CAR photoresist performance will be compared. We will review step by step etch chemistry development to reach adequate selectivity and roughness reduction to successfully pattern the target layer.
Even in a 1D design style, single exposure of the 16 nm half-pitch M2 layer is very challenging for EUV lithography, because of its tight tip-to-tip configurations. Therefore, the industry is considering the hybrid use of ArFi-based SAQP combined with EUV Block as an alternative to EUV single exposure. As a consequence, the EUV Block layer may be one of the first layers to adopt EUV lithography in HVM.
In this paper, we report on the imec iN7 SAQP + Block litho performance and process integration, targeting the M2 patterning for a 7.5 track logic design. The Block layer is exposed on an ASML NXE:3300 EUV-scanner at imec, using optimized illumination conditions and state-of-the-art metal-containing negative tone resist (Inpria). Subsequently, the SAQP and block structures are characterized in a morphological study, assessing pattern fidelity and CD/EPE variability. The work is an experimental feasibility study of EUV insertion, for SAQP + Block M2 patterning on an industry-relevant N5 use-case.
View contact details
No SPIE Account? Create one
